pressure ding

[hansen]

so I skimmed over a rock the other day and now I got a pressure ding on the bottem of my poly. How should I go about fixing this? Is it even that big of a problem? Its about the size of a nickel and does not go in too far. You kind have to feel it to notice it. Am I just stressing too much?

[shin-n]

shouldnt be a big deal if their that small
post a pic of the ding

[didj prophet]

the answer would be yes, you are stressing too much, pressure dings are normal, they will happen, as long as it is just a ding and not a crack or a hole it's nothing to worry about, you should worry when the foam is exposed, because leaving foam exposed will eventually cause your board to delaminate and it will be done for

[kcskimkid]

pressure dings are normal. i have one on top of my board from my heel.ur fine

[Tear Down Your Idols]

totally normal only use sun cure is its exposing the inside.

[Brave H]

tell the day I die tabbaco and super glue... amen. (keep in mind this is for a real ding though)

I don't worry about pressure dings to much, if it doesn't break the skin of the board... figure its all part of the character of the board... Ive got a couple on my board now...

[Rockporter9]

as long as the foam is not exposed you're fine, but if it is sun cure it

[bahamaskimmer]

shin-n, that advatar is mighty gay

[senortetas]

shin-n, that advatar is mighty gay

haha i was just thinking.. 'is this the skimonline boards or fucking myspace?!' with the pic of his ab's